AIR FUEL RATIO SENSOR (for 2WD) > INSTALLATION |
| 1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, install the sensor to the exhaust manifold LH.
Connect the sensor connector.
| 2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, install the sensor to the exhaust manifold RH.
| 3. INSTALL EXHAUST MANIFOLD RH |
![]() |
Install the exhaust manifold RH with a new gasket and 6 nuts.
![]() |
Install the exhaust manifold stay with the nut and bolt.
Connect the air fuel ratio sensor (for Bank 1 Sensor 2) connector.
| 4. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Check compression springs.
Check the compression springs using vernier calipers.
![]() |
Install the gasket.
Install a new gasket by hand onto the front exhaust pipe assembly.
Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the front exhaust pipe.
Install 2 new gaskets to the front exhaust pipe assembly.
Install the front exhaust pipe assembly with the 4 nuts.

![]() |
Install the center exhaust pipe assembly with the 2 compression springs and 2 bolts.
Install the No. 1 exhaust pipe support bracket with the 2 new nuts.

Connect the heated oxygen sensor (for Bank 1 sensor 2) connector.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. INSPECT FOR EXHAUST GAS LEAK |