Home › ENGINE › 2GR-FE EMISSION CONTROL › AIR FUEL RATIO SENSOR (for 2WD)

AIR FUEL RATIO SENSOR (for 2WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A162948E01
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the exhaust manifold.

    SST
    09224-00010  



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor (for Bank 1 Sensor 2) connector under the center console.



    A162949
  1. Remove the 2 bolts and 2 compression springs.



  1. Remove the 6 nuts and front exhaust pipe assembly.


    A162483



4. REMOVE EXHAUST MANIFOLD RH


    A162950
  1. Remove the nut, bolt and exhaust manifold stay.

  1. Disconnect the air fuel ratio sensor (for Bank 1 Sensor 1) connector.



    A162951
  1. Remove the 6 nuts and exhaust manifold RH.

  1. Remove the gasket and exhaust manifold to head gasket.



5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A163254E01
  1. Using SST, remove the sensor.

    SST
    09224-00010