Home › ENGINE › 2GR-FE EMISSION CONTROL › AIR FUEL RATIO SENSOR (for 4WD)

AIR FUEL RATIO SENSOR (for 4WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A162948E01
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the exhaust manifold.

    SST
    09224-00010  



3. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor (for Bank 1 Sensor 2) connector under the center console.



    A163447
  1. Remove the clip as shown in the illustration.



    A162949
  1. Remove the 2 bolts and 2 compression springs.



  1. Remove the 2 bolts, 2 nuts and center exhaust pipe assembly.


    A163384



4. REMOVE EXHAUST MANIFOLD RH


    A162950
  1. Remove the nut, bolt and exhaust manifold stay.



    A162951
  1. Remove the 6 nuts and exhaust manifold RH.

  1. Remove the gasket and exhaust manifold to head gasket.



5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A163254E01
  1. Using SST, remove the sensor.

    SST
    09224-00010