AIR FUEL RATIO SENSOR (for 4WD) > ON-VEHICLE INSPECTION |
| 1. CHECK AIR FUEL RATIO COMPENSATION SYSTEM |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Select the following menu items: Powertrain / Engine and ECT / Data List / AFS B1 S1, AFS B2 S1, O2S B1 S2 and O2S B2 S2.
Warm up the A/F sensor with the engine speed at 2500 rpm for approximately 2 minutes.
![]() |
Keep the engine speed at 2500 rpm and confirm that the AFS B1 S1 and AFS B2 S1 display is as shown in the illustration.
| Tester Display (Sensor) | Injection Volume | Status | Voltage |
| AFS B1 S1 (A/F) | +25% | Rich | Less than 3.0 |
| -12.5% | Lean | More than 3.35 | |
| AFS B2 S1 (A/F) | +25% | Rich | Less than 3.0 |
| -12.5% | Lean | More than 3.35 |
Confirm that the O2S B1 S2 and O2S B2 S2 display changes between 0 to 1 V with the engine speed at 2500 rpm.