Home › ENGINE › 2GR-FE EMISSION CONTROL › HEATED OXYGEN SENSOR (for 2WD)

HEATED OXYGEN SENSOR (for 2WD) > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A163271E01
  1. Using SST, install the heated oxygen sensor to the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and a wrench are connected in a straight line.



2. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    A077857
  1. Check the compression springs.

    1. Check the compression springs using vernier calipers.

      Specified length:
      38.86 mm (1.5299 in.)

      HINT:
      If the result is not as specified, replace the compression spring.



    A076194E04
  1. Install the gasket.

    1. Install a new gasket by hand onto the front exhaust pipe assembly.

    2. Using a plastic hammer and wooden block, tap in the new gasket until its surface is flush with the front exhaust pipe.

      NOTICE:
      1. Be careful with the installation direction of the gasket.
      2. Do not damage the gasket.
      3. Do not reuse the gasket.
      4. To ensure a proper seal, do not use the exhaust pipe to force the gasket on to the front exhaust pipe.

  1. Install 2 new gaskets to the front exhaust pipe assembly.



  1. Install the front exhaust pipe assembly with the 4 nuts.

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }



    A162908



    A162949
  1. Install the front exhaust pipe assembly with the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



  1. Install the No. 1 exhaust pipe support bracket with 2 new nuts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



    A165516

  1. Connect the heated oxygen sensor (for Bank 2 sensor 2) connector.



3. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A162954E01
  1. Using SST, install the heated oxygen sensor.

    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and a wrench are connected in a straight line.

  1. Connect the heated oxygen sensor (for Bank 1 Sensor 2) connector.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. INSPECT FOR EXHAUST GAS LEAK