Home › ENGINE › 2GR-FE EMISSION CONTROL › HEATED OXYGEN SENSOR (for 2WD)

HEATED OXYGEN SENSOR (for 2WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the nagative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the sensor connector under the center console.



    A162954E01
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor (for Bank 2 Sensor 2) connector.



    A162949
  1. Remove the 2 bolts and 2 compression springs.



  1. Remove the 6 nuts and front exhaust pipe assembly.


    A162483



4. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A163269E01
  1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

    SST
    09224-00010