Home › ENGINE › 2GR-FE EMISSION CONTROL › HEATED OXYGEN SENSOR (for 4WD)

HEATED OXYGEN SENSOR (for 4WD) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the sensor connector under the center console.



    A163385E02
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor (for Bank 2 Sensor 2) connector.



  1. Remove the 2 bolts, 4 nuts and front exhaust pipe assembly.


    A162957



4. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A163269E01
  1. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.