Home › DRIVE LINE › DRIVE SHAFT › REAR DRIVE SHAFT (for 4WD)

REAR DRIVE SHAFT (for 4WD) > INSPECTION

for Preparation Click here



1. INSPECT REAR DRIVE SHAFT ASSEMBLY LH


    Z012871
  1. Check that there is no remarkable play in the radial direction of the outboard joint.

  1. Check that the inboard joint slides smoothly in the thrust direction.

  1. Check that there is no remarkable play in the radial direction of the inboard joint.

  1. Check the boots for damage.



    Z013445E01
  1. Make sure that the 2 boots are not stretched or contracted when the drive shaft is at standard length.

    Standard length:
    704.8 +- 5.0 mm (27.748 +- 0.20 in.)