Home › DRIVE LINE › DRIVE SHAFT › FRONT DRIVE SHAFT

FRONT DRIVE SHAFT > INSPECTION

for Preparation Click here



1. INSPECT FRONT DRIVE SHAFT ASSEMBLY LH


    C091598
  1. Check that there is no remarkable play in the radial direction of the outboard joint.

  1. Check that the inboard joint slides smoothly in the thrust direction.

  1. Check that there is no remarkable play in the radial direction of the inboard joint.

  1. Check the boots for damage.



    F045048E03
  1. For dimension (A), refer to the following table.
    DRIVE TYPE
    LH mm (in.)
    RH mm (in.)
    2WD
    638.40 +- 5.0 (25.1338 +- 0.20)
    957.00 +- 5.0 (37.6771 +- 0.20)
    4WD
    553.64 +- 5.0 (21.7968 +- 0.20)
    992.24 +- 5.0 (39.0645 +- 0.20)