Home › BRAKE › PARKING BRAKE › PARKING BRAKE SYSTEM

PARKING BRAKE SYSTEM > ADJUSTMENT

for Preparation Click here



1. REMOVE REAR WHEEL


2. ADJUST PARKING BRAKE SHOE CLEARANCE


    F040026E02
  1. Temporarily install the hub nuts.

  1. Remove the hole plug, and turn the adjuster and expand the shoes until the disc locks.

  1. Contract the shoe adjuster until the disc can rotate smoothly.

    Standard:
    Return 8 notches

  1. Check that the brake disc rotates smoothly.

  1. Install the hole plug.



3. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. INSPECT PARKING BRAKE PEDAL TRAVEL
  1. Slowly depress the parking brake pedal all the way, and count the number of clicks.

    Parking brake pedal travel:
    3 to 5 clicks at 294 N (30 kgf, 66.0 lbf)



5. DISCONNECT BATTERY NEGATIVE TERMINAL


6. REMOVE FRONT DOOR SCUFF PLATE LH


7. REMOVE COWL SIDE TRIM BOARD LH


    B066070E01
  1. Remove the 2 bolts <A>.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the 2 claws and 3 clips, and then remove the instrument panel finish panel sub-assembly lower LH.

  1. Disconnect the connectors.



8. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH


9. ADJUST PARKING BRAKE PEDAL TRAVEL
  1. Depress the parking brake pedal 3 notches to make a room for the procedure, and loosen the lock nut.

  1. Return the parking brake pedal to the original position.

  1. Turn the adjusting nut until the parking brake pedal travel corrects.



    F045024E01
  1. Depress the parking brake pedal 3 notches to make a room for the procedure, and tighten the lock nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Return the parking brake pedal to the original position.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake pedal, check that the parking brake pedal indicator light goes on.