Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    G024262
  1. Install the brake pedal support sub-assembly with the 4 nuts.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

  1. Install the clip and clevis pin to the brake pedal lever.

  1. Using needle-nose pliers, install the tension spring.



    G024263
  1. Install the 2 bolts to the brake pedal bracket No. 3.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. Install the stop light switch harness clamp to the brake pedal support sub-assembly.

  1. Connect the stop light switch connector.



2. FULLY TIGHTEN BRAKE PEDAL SHAFT


    F045360E01
  1. Fully tighten the 2 brake pedal shafts.

    Torque:
    34 N*m{ 350 kgf*cm , 25 ft.*lbf }



3. INSTALL INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY NO. 1
  1. Install the instrument panel safety pad insert sub-assembly No. 1 with the 4 bolts.



4. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH
  1. Install the instrument panel finish panel sub-assembly lower LH with the 2 bolts.



5. INSTALL COWL SIDE TRIM BOARD LH


6. INSTALL FRONT DOOR SCUFF PLATE LH


7. INSPECT BRAKE PEDAL HEIGHT


    G024663E01
  1. Check the brake pedal height.

    Pedal height from dash panel:
    150.3 to 160.3 mm (5.917 to 6.311 in.)

    NOTICE:
    Do not adjust the pedal height. Doing so by changing the push rod length will structurally change the pedal ratio.



8. CHECK PEDAL FREE PLAY


    G024662E01
  1. Stop the engine and depress the brake pedal several times until there is no more vacuum left in the booster.

  1. Push in the pedal until the beginning of the resistance is felt. Measure the distance, as shown.

    Pedal free play:
    1 to 6 mm (0.04 to 0.24 in.)



9. CHECK PEDAL RESERVE DISTANCE


    R000934E13
  1. Release the parking brake pedal.
    With the engine running, depress the pedal and measure the pedal reserve distance, as shown.

    Pedal reserve distance from asphalt sheet at 490 N (50 kgf, 110 lbf):
    More than 52 mm (2.0 in.)

    HINT:
    If the distance is out of the specification, troubleshoot the brake system.