Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. SEPARATE BATTERY NEGATIVE TERMINAL


2. REMOVE FRONT DOOR SCUFF PLATE LH


3. REMOVE COWL SIDE TRIM BOARD LH


4. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH
  1. Remove the 2 bolts and instrument panel finish panel sub-assembly lower LH.



5. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY NO. 1
  1. Remove the 4 bolts and instrument panel safety pad insert sub-assembly No. 1.



6. LOOSEN BRAKE PEDAL SHAFT


    F045360E01
  1. Loosen the 2 brake pedal shafts.



7. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    G024262
  1. Remove the 4 nuts and brake pedal support sub-assembly.

  1. Using needle-nose pliers, remove the tension spring.

  1. Remove the clip and clevis pin from the brake pedal lever.



    G024263
  1. Remove the 2 bolts from the brake pedal bracket No. 3.

  1. Remove the stop light switch harness clamp from the brake pedal support sub-assembly.

  1. Disconnect the stop light switch connector.