Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE PEDAL PAD
  1. Install the brake pedal pad to the brake pedal sub-assembly.



2. INSTALL PUSH ROD PIN
  1. Apply lithium soap base glycol grease to inside surface of 2 new push rod bushes.

  1. Install the 2 new push rod bushes.

  1. Install the 2 push rod pins with the 2 plate to the brake pedal.

  1. Using needle-nose pliers, install the 2 new E-rings to the 2 push rod pins.

    NOTICE:
    Install the E-ring securely to the grooves of the push rod pin.



3. INSTALL BRAKE PEDAL BUSH
  1. Apply lithium soap base glycol grease to inside surface of 4 new brake pedal bushes.

  1. Install the 4 brake pedal bushes to the brake pedal.



4. INSTALL BRAKE PEDAL SHAFT COLLAR
  1. Apply the lithium soap base glycol grease to inside surface of 2 brake pedal shaft collars.

  1. Install the 2 brake pedal shaft collars to the brake pedal.



5. INSTALL BRAKE PEDAL
  1. Install the 2 brake pedal shafts, 2 nuts, brake pedal and brake pedal bracket No. 3 to the brake pedal support sub-assembly.



6. INSTALL STOP LIGHT SWITCH CUSHION
  1. Install the stop light switch cushion to the brake pedal sub-assembly.



7. INSTALL STOP LIGHT SWITCH ASSEMBLY
  1. Install the stop light switch mounting adjuster to the brake pedal support sub-assembly.

  1. Install the stop light switch assembly until the body hits the cushion.

  1. Make a quarter turn clockwise to install the stop light switch assembly.

    NOTICE:
    The turning torque for installing the stop light switch assembly.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    HINT:
    Due to the inverse screw structure, if the stop light switch assembly is turned clockwise, the stop light switch assembly moves in the direction to be pulled out.