Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BRAKE PEDAL HEIGHT


    G024663E01
  1. Check the brake pedal height.

    Pedal height from dash panel:
    150.3 to 160.3 mm (5.917 to 6.311 in.)

    NOTICE:
    Do not adjust the pedal height. Doing so by changing the push rod length will structurally change the pedal ratio.



2. CHECK AND ADJUST STOP LIGHT SWITCH
  1. Disconnect the stop light switch assembly connector from the stop light switch assembly.

  1. Turn the stop light switch assembly counterclockwise and remove the stop light switch assembly.



    F045347E03
  1. Insert the stop light switch assembly until the body hits the cushion.

    NOTICE:
    When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



    F043108E06
  1. Make a quarter turn clockwise to install the stop light switch assembly.

    NOTICE:
    1. When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
    2. The turning torque for installing the stop light switch assembly.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

  1. Connect the stop light switch connector to the stop light switch assembly.

  1. Check the protrusion of the rod.

    Protrusion of the rod:
    0.5 to 2.5mm (0.020 to 0.098 in.)



3. CHECK PEDAL FREE PLAY


    G024662E01
  1. Stop the engine and depress the brake pedal several times until there is no more vacuum left in the booster.

  1. Push in the pedal until the beginning of the resistance is felt. Measure the distance, as shown.

    Pedal free play:
    1 to 6 mm (0.04 to 0.24 in.)



4. CHECK PEDAL RESERVE DISTANCE


    R000934E13
  1. Release the parking brake pedal.
    With the engine running, depress the pedal and measure the pedal reserve distance, as shown.

    Pedal reserve distance from asphalt sheet at 490 N (50 kgf, 110 lbf):
    More than 52 mm (2.0 in.)

    HINT:
    If the distance is out of the specification, troubleshoot the brake system.