Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > REMOVAL

for Preparation Click here


NOTICE:
  1. Do not adjust the brake booster push rod.
  2. Do not change the combination of the diameter converting unit and brake.
  3. Release the vacuum from the booster by depressing the brake pedal several times. Then remove the brake master cylinder from the brake booster.



1. DRAIN BRAKE FLUID

NOTICE:
Wash the brake fluid off immediately if it adheres to any painted surfaces.



2. SEPARATE BATTERY NEGATIVE TERMINAL


3. REMOVE AIR CLEANER ASSEMBLY WITH HOSE


4. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT

HINT:
When removing or installing the front shock absorber with coil spring RH, it is necessary to remove the cowl top panel sub-assembly outer front.

  1. Disconnect the wire harness from the cowl top panel sub-assembly outer front.



    F049306E01
  1. Remove the 9 bolts, cowl top brace and cowl top panel sub-assembly outer front.



5. REMOVE BRAKE MASTER CYLINDER


    G024301
  1. Using SST, disconnect the 2 brake tubes from the brake master cylinder assembly.

    SST
    09023-00101  

  1. Slide the clip and disconnect the brake master cylinder reservoir hose.



    G024300
  1. Remove the 2 nuts and brake master cylinder.