Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > DISASSEMBLY

for Preparation Click here



1. REMOVE BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY
  1. Using soft jaws on the vise, hold the brake master cylinder in a vise through aluminum plates.

  1. Using a screwdriver, remove the O-ring.



    G024299
  1. Using SST, remove the brake tube from the brake master cylinder.

    SST
    09023-00101  



    G024298
  1. Remove the 2 nuts, 2 bolts and brake master less reservoir tank cylinder sub-assembly.

    NOTICE:
    1. Pay due attention so as not to drop the No. 3 piston from the diameter converting unit. (if the No. 3 piston drops, it cannot be reused.)
    2. Pay due attention so as not to drop the No. 1 piston from the plunger master cylinder. (if the No. 1 piston drops, it cannot be reused.)



    G024283
  1. Using a screwdriver, remove the 2 O-rings.



    G024282
  1. Using a pin punch (φ 5 mm) and hammer, remove the pin.

  1. Remove the brake master cylinder union and 2 brake master cylinder union grommets.