Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY
  1. Apply lithium soap base glycol grease to the 2 brake master cylinder union grommets and install them to the brake master less reservoir tank cylinder sub-assembly.

  1. Using a pin punch (φ 5 mm) and hammer, install the master cylinder union with the pin.

  1. Install the 2 new O-rings.



    G024298
  1. Install the brake master less reservoir tank cylinder sub-assembly with the 2 nuts and, 2 bolts.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    When the diameter converting unit and master cylinder are connected, install the No. 3 piston with no looseness.



    G024299
  1. Using SST, install the brake tube to the brake master cylinder.

    SST
    09023-00101  

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

  1. Install the new O-ring.