FRONT BRAKE > DISASSEMBLY |
| 1. REMOVE FRONT DISC BRAKE BUSH DUST BOOT |
Using soft jaws on the vise, hold the front disc brake cylinder mounting LH in the vise through aluminum plates.
![]() |
Using a screwdriver and hammer, remove the 2 front disc brake bush dust boots from the front disc brake cylinder mounting LH.
| 2. REMOVE CYLINDER BOOT |
![]() |
Using a screwdriver, remove the set ring and cylinder boot.
| 3. REMOVE FRONT DISC BRAKE PISTON |
Place a shop rug, between the front disc brake piston and the disc brake cylinder sub-assembly.
![]() |
Use compressed air to remove the front disc brake piston from the disc brake cylinder sub-assembly.
| 4. REMOVE PISTON SEAL |
![]() |
Using a screwdriver, remove the piston seal from the front disc brake cylinder sub-assembly.
| 5. REMOVE FRONT DISC BRAKE BLEEDER PLUG |
Remove the front disc brake bleeder plug from the front disc brake cylinder sub-assembly.
| 6. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP |
| 7. REMOVE FRONT DISC |
![]() |
Place matchmarks on the front disc and the axle hub.
Remove the front disc.