REAR DRUM BRAKE > DISASSEMBLY |
| 1. REMOVE REAR WHEEL |
| 2. DRAIN BRAKE FLUID |
| 3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
Release the parking brake lever, and remove the rear brake drum.
![]() |
Remove the hole plug and insert a screwdriver through the hole in the backing plate, and hold the automatic adjusting lever away from the adjuster.
Using another screwdriver, reduce the brake shoe adjuster by turning the adjusting wheel.
| 4. REMOVE FRONT BRAKE SHOE |
![]() |
Using SST, remove the shoe return spring from the front brake shoe.
![]() |
Using a needle-nose pliers, remove the return spring.
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.
Remove the parking brake shoe strut LWR.
Remove the tension spring and front brake shoe.
Remove the automatic adjust lever spring and rear brake automatic adjust lever LH from the front brake shoe.
| 5. REMOVE REAR BRAKE SHOE |
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring and pin.
![]() |
Using a needle-nose pliers, disconnect the parking brake cable No. 3 and remove the rear brake shoe.
![]() |
Using a screwdriver, remove the 2 C-washers, parking brake shoe lever, parking brake reaction lever LH and rear brake strut set.
| 6. REMOVE LH, FRONT OR UPPER REAR WHEEL BRAKE CYLINDER ASSEMBLY |
Using SST, disconnect the brake tube, use a container to catch the brake fluid.
![]() |
Remove the 2 bolts and rear wheel brake cylinder assembly.
| 7. REMOVE REAR WHEEL CYLINDER CUP KIT |
Remove the 2 cylinder dust boots from the rear wheel brake cylinder assembly.
Remove the 2 pistons and compression spring.
Remove the 2 wheel cylinder cups from each piston.
Remove the bleeder plug cap and bleeder plug from the rear wheel brake cylinder assembly.