Home › BRAKE › BRAKE › REAR DISC BRAKE

REAR DISC BRAKE > REMOVAL

for Preparation Click here


HINT:
Remove the RH side by the same procedure as the LH side.



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash the brake fluid off immediately if it attaches to any painted surface.



3. SEPARATE REAR BRAKE TUBE NO.4
  1. Remove the clip and a disconnect, the rear brake flexible hose.



    C065884
  1. Using SST and spanner loosen the rear brake tube No. 4.

    SST
    09023-00101  



4. SEPARATE REAR LH FLEXIBLE HOSE


    C090476
  1. Using SST, remove the rear brake flexible hose.

    SST
    09023-12701  



5. REMOVE DISC BRAKE CYLINDER ASSEMBLY REAR LH


    C085507
  1. Hold the rear disc brake cylinder slide pin and remove the 2 bolts.

  1. Remove the disc brake cylinder assembly rear LH from the rear disc brake cylinder mounting LH.



6. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN
  1. Remove the 2 rear disc brake cylinder slide pins from the rear disc brake cylinder mounting LH.



7. REMOVE REAR DISC BRAKE BUSH DUST BOOT
  1. Remove the 2 rear disc brake bush dust boots.



8. REMOVE DISC BRAKE PAD KIT REAR (PAD ONLY)
  1. Remove the disc brake pad kit rear.



9. REMOVE REAR DISC BRAKE ANTI SQUEAL SHIM KIT
  1. Remove the anti squeal shim No. 1 and anti squeal shim No. 2 from each pad.



10. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
  1. Remove the rear disc brake pad support plate (No. 1) and rear disc brake pad support plate (No. 2) from the rear disc brake cylinder mounting LH.



11. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH
  1. Remove the bolts and rear disc brake cylinder mounting LH.