Home › BRAKE › BRAKE › REAR DISC BRAKE

REAR DISC BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    F012033
  1. Using a screwdriver, remove the set ring and cylinder boot.



2. REMOVE REAR DISC BRAKE PISTON
  1. Place a shop rug, between the rear disc brake piston and the disc brake cylinder.



    F012034
  1. Use compressed air to remove the rear disc brake piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter the brake fluid.



3. REMOVE PISTON SEAL


    F012035
  1. Using a screwdriver, remove the piston seal from the disc brake cylinder assembly rear LH.

    NOTICE:
    Do not damage the inner cylinder and cylinder groove.



4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP


5. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the rear disc brake bleeder plug from the disc brake cylinder assembly rear LH.



6. REMOVE REAR DISC


    F041543E13
  1. Make matchmarks on the rear disc and the axle hub.

  1. Remove the rear disc.