TRANSMISSION CONTROL CABLE ASSEMBLY > REMOVAL |
| 1. DISCONNECT BATTERY NEGATIVE TERMINAL |
| 2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER |
| 3. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut from the control shaft lever.
Disconnect the transmission control cable assembly from the control shaft lever.
![]() |
Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.
![]() |
Disconnect the transmission control cable assembly from the transmission control cable bracket No.2.
![]() |
Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle.
![]() |
Using a screwdriver, disconnect the cable end from the shift lever assembly
Using a small screwdriver, disconnect the cable outer of transmission control cable assembly from the shift lever assembly.
Pull out the control cable from the vehicle.