Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR (for 2WD)

REAR SPEED SENSOR (for 2WD) > INSPECTION

for Preparation Click here



1. INSPECT REAR SPEED SENSOR
  1. Disconnect the skid control sensor connector.



    F041836E22
  1. Measure the resistance between terminals 1 and 2 of the skid control sensor connector.

    OK:
    Resistance:
    less than 2.2 kΩ

  1. Measure resistance between each of terminals 1 and 2 of the skid control sensor connector and body ground.

    OK:
    Resistance:
    1MΩ or higher