Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR (for 2WD)

REAR SPEED SENSOR (for 2WD) > REMOVAL

for Preparation Click here


HINT:
Remove the RH by the same procedure as the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE SKID CONTROL SENSOR WIRE


    G024268
  1. Disconnect the connector from the skid control sensor.



3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type)
  1. Place matchmarks on the rear brake drum sub-assembly and the axle hub.

  1. Remove the rear brake drum sub-assembly.



4. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH (for Disc Type)
  1. Remove the 2 bolts and rear brake caliper assembly LH.



5. REMOVE REAR DISC (for Disc Type)
  1. Place matchmarks on the rear disc and the axle hub.

  1. Remove the rear disc.



6. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH


    C066210E04
  1. Remove the 4 nuts and hub & bearing assembly LH.



7. REMOVE REAR SPEED SENSOR
  1. Mount the rear axle hub in a soft jaw vise.

    NOTICE:
    Replace the axle hub assembly if it is dropped or a strong shock is given to it.

  1. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.



    F040303E03
  1. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.

    SST
    09520-00031   (09520-00040)
    09521-00020  
    09950-00020  

    NOTICE:
    1. If a damage is inflicted to the sensor rotor is damaged, replace the axle hub assembly.
    2. Do not scratch the contacting surface of the axle hub and speed sensor.