Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR (for 4WD)

REAR SPEED SENSOR (for 4WD) > INSTALLATION

for Preparation Click here


HINT:
Install the RH side by same procedure as the LH side.



1. INSTALL REAR SPEED SENSOR


    G023898
  1. Install the speed sensor rear LH with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    Keep the tip of the speed sensor rear LH clean.



    G024305
  1. Install the sensor harness clamps with the bolts to the body.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Push in the sensor wire harness with grommet.

    NOTICE:
    When grommet i set to body, pull the grommet, and don't pull the sensor wire.



    F040305
  1. Connect the speed sensor connector.



2. INSTALL QUARTER TRIM PANEL ASSEMBLY LH


3. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. CHECK ABS SPEED SENSOR SIGNAL

HINT:
Click here.