Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR (for 4WD)

REAR SPEED SENSOR (for 4WD) > INSPECTION

for Preparation Click here



1. INSPECT REAR SPEED SENSOR
  1. Remove the seat cushion and seatback.

  1. Disconnect the speed sensor connector.



    F013045E09
  1. Measure the resistance between terminals 1 and 2 of the speed sensor connector.

    OK:
    Resistance:
    1.1 +- 0.2 kΩ at 25 +- 5 °C

  1. Measure the resistance between each of terminals 1 and 2 of skid control sensor connector and body ground.

    OK:
    Resistance:
    1 MΩ or higher

    NOTICE:
    Check the speed sensor signal last (Click here).