Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR (for 4WD)

REAR SPEED SENSOR (for 4WD) > REMOVAL

for Preparation Click here


HINT:
Remove the RH side by the same procedure as the LH side.



1. REMOVE REAR WHEEL


2. REMOVE QUARTER TRIM PANEL ASSEMBLY FRONT LH

HINT:
Remove the LH side by the same procedure as the RH side .



3. REMOVE REAR SPEED SENSOR


    F040305
  1. Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.



    G024305
  1. Remove the clamp bolt holding the sensor harness from the body.



    G023898
  1. Remove the bolt and speed sensor rear LH.

    NOTICE:
    Keep the tip of the speed sensor rear LH clean.