Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

HINT:
Click here



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. SEPARATE BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



4. REMOVE HORN BUTTON ASSEMBLY


    H042695E01
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    H042674
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



5. REMOVE STEERING WHEEL ASSEMBLY


    F044997E02
  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



6. REMOVE STEERING COLUMN COVER LWR


    H042796
  1. Remove the 2 screws and the steering column cover.



7. REMOVE SPIRAL CABLE SUB-ASSEMBLY
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    H042636E01
  1. Disengage the 3 claws and remove the spiral cable.



8. REMOVE STEERING ANGLE SENSOR


    F045466
  1. Release the claw fittings and remove the steering sensor from the spiral cable.