Home › BODY › ENGINE HOOD / DOOR › SLIDE DOOR CLOSER SYSTEM

SLIDE DOOR CLOSER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the DATA LIST displayed on the Techstream, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. According to the display on the tester, read the DATA LIST.

    Power slide door ECU LH/RH: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Pole* Switch
    Power slide door lock pawl* position switch signal
    / ON or OFF
    ON: Slide door is unlatched
    OFF: Slide door is latched
    -
    Half Switch
    Power slide door lock half-latch switch signal
    / ON or OFF
    ON: Slide door is not completely closed
    OFF: Slide door is closed
    -
    Full Switch
    Power slide door lock full-latch switch signal
    / ON or OFF
    ON: Slide door is open
    OFF: Slide door is closed
    -
    Closer Position Switch
    Power slide door lock closer position switch signal
    / ON or OFF
    ON: Closer is not in the initial position and inside / outside handle is not pulled
    OFF: Closer is in the initial position and inside / outside handle is pulled
    -
    * "Pole" appears on the display of the Techstream, however the name of the part corresponding to the display of the tester is "pawl".