Home › BODY › ENGINE HOOD / DOOR › POWER SLIDE DOOR SYSTEM

POWER SLIDE DOOR SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the DATA LIST displayed on the Techstream, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Read the DATA LIST according to the display on the tester.

    Power slide door ECU LH/RH: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Pole*1 Switch
    Power slide door lock pawl*1 position switch signal
    / ON or OFF
    ON: Slide door is unlatched
    OFF: Slide door is latched
    -
    Half Switch
    Power slide door lock half latch switch signal
    / ON or OFF
    ON: Slide door is not completely closed
    OFF: Slide door is closed
    -
    Full Switch
    Power slide door lock full latch switch signal
    / ON or OFF
    ON: Slide door is open
    OFF: Slide door is closed
    -
    PSD SW Operation
    Power slide door switch operation (Satellite switch)
    / 0.8s or 0.0s*2
    0.8s: Satellite switch 0.8sec.-press (long press) operates power slide door
    0.0s*2: Satellite switch 1-press operates power slide door
    -
    Buzz Vol PSD Operation
    Warning buzzer volume during power slide door operation
    / OFF, SMALL or LARGE
    OFF: Warning buzzer that notifies power slide door is operating does not sound
    SMALL: Warning buzzer that notifies power slide door is operating sounds at small volume
    LARGE: Warning buzzer that notifies power slide door is operating sounds at large volume
    -
    Wirels PSD SW Operation
    Wireless power slide door switch operation (Transmitter switch operation)
    / 1TIME, 2TIME, 0.8sPR or OFF
    1TIME: Transmitter switch 1-press operates power slide door
    2TIMES: Transmitter switch 2-presses operates power slide door
    0.8sPR: Transmitter switch 0.8s.-press operates power slide door
    OFF: Transmitter switch operation is disabled
    -
    PSD Touch Sensor
    Power slide door touch sensor signal
    / OFF, ON or OPEN
    OFF: Power slide door touch sensor is not pressed
    ON: Power slide door touch sensor is pressed
    OPEN: Power slide door touch sensor is opened
    -
    Closer Position Switch
    Power slide door lock closer position switch signal
    / ON or OFF
    ON: Closer is not in initial position and inside / outside handle is not pulled
    OFF: Closer is in initial position and inside / outside handle is pulled
    -
    Handle Switch
    Handle operation detect switch signal
    / ON or OFF
    ON: Slide door inside / outside handle is pulled
    OFF: Slide door inside / outside handle is not pulled
    -
    PSD Main Switch
    Power slide door main switch signal
    / ON or OFF
    ON: Orange paint on top of switch appears
    OFF: Orange paint on top of switch does not appear
    -
    B Pillar Switch*3
    Power slide door control switch*3 signal
    / ON or OFF
    ON: Power slide door control switch*3 is pushed
    OFF: Power slide door control switch*3 is not pushed
    -
    Child Lock Switch
    Child protection detect switch signal
    / ON or OFF
    ON: Child lock lever is LOCK
    OFF: Child lock lever is UNLOCK
    -
    Fuel Lid Switch*4
    Fuel lid courtesy switch signal
    / ON or OFF
    ON: Fuel lid is closed
    OFF: Fuel lid is open
    -
    Door Position
    (Close - 1/4)
    Slide door position (Full close - 1/4 open)
    / CAUTION or OK
    CAUTION: Slide door position is not fully closed - 1/4 opened
    OK: Slide door position is fully closed - 1/4 opened
    *5
    Door Position
    (1/4 - 2/4)
    Slide door position (1/4 open - 2/4 open)
    / CAUTION or OK
    CAUTION: Slide door position is not 1/4 opened - 2/4 opened
    OK: Slide door position is 1/4 opened - 2/4 opened
    *5
    Door Position
    (2/4 - 3/4)
    Slide door position (2/4 open - 3/4 open)
    / CAUTION or OK
    CAUTION: Slide door position is not 2/4 opened - 3/4 opened
    OK: Slide door position is 2/4 opened - 3/4 opened
    *5
    Door Position
    ( 3/4 - Open)
    Slide door position (3/4 open - full open)
    / CAUTION or OK
    CAUTION: Slide door position is not 3/4 opened - fully opened
    OK: Slide door position is 3/4 opened - fully opened
    *5
    *1 "Pole" appears on the display of the Techstream, however the name of the part corresponding to the display of the tester is "pawl".
    *2 "0.0s" appearing on the display of the Techstream means that a 1-press of the satellite switch operates the power slide door.
    *3 "B Pillar Switch" appears on the display of the Techstream, however the name of the part corresponding to the display of the tester is "Power slide door control switch".
    *4 Power slide door ECU LH only.
    *5 In case that the "CAUTION" is displayed even without resistance applied in each range, there must be a foreign object caught somewhere in that range.


ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the Techstream allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten the labor time. It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Perform the ACTIVE TEST according to the display on the tester.

    Power Slide Door ECU LH/RH 
    Tester Display
    Test Part
    Control Range
    PSD Motor
    Power slide door control motor is operation
    OFF / FORWARD / REVERAE
    Clutch is OFF while power slide door motor is operating
    PSD Clutch
    Power slide door control clutch is release
    OFF / ON
    Power slide door motor is OFF when clutch is ON
    PSD Buzzer
    Power slide door warning buzzer sound
    OFF / ON
    -
    Release Actuator
    Slide door lock release motor is release
    OFF / ON
    -