DTC B2224 Power Slide Door Pulse Sensor Malfunction on Rear Left Door |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2224 | Power slide door LH does not operate |
|

| 1.CHECK WIRE HARNESS (MOTOR AND CLUTCH LH - POWER SLIDE DOOR ECU LH) |
![]() |
Disconnect the P21 motor and clutch, and the P25 ECU connectors.
Check the continuity between the wire harness side connectors.
| Terminal No. | Specified Condition |
| P21-9 - P25-23 (DSG) | Below 1 Ω |
| P21-4 - P25-26 (DSV) | |
| P21-5 - P25-25 (DS1) | |
| P21-10 - P25-24 (DS2) |
|
| ||||
| OK | |
| 2.INSPECT SLIDE DOOR CONTROL MOTOR AND CLUTCH ASSEMBLY LH |
![]() |
Remove the motor and clutch.
Connect the battery positive (+) lead to terminal 3 and battery negative (-) terminal lead to terminal 2.
Apply battery voltage to the terminals and check the motor operation.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 8 Battery negative (-) → Terminal 7 | Open |
| Battery positive (+) → Terminal 7 Battery negative (-) → Terminal 8 | Close |
Check the resistance of the clutch terminals.
| Terminal No. | Specified Condition |
| 2 - 3 | 4.0 Ω |
Reinstall the motor and clutch with the connector connected.
![]() |
Check the pulse of the pulse sensor.
Using an oscilloscope, check the pulse generated when the door is manually opened and closed.
| Terminal | Tool setting | Vehicle condition |
| 5 - 9, 9 - 10 | 10 V/DIV., 10 ms/DIV. | Door moving |
|
| ||||
| OK | ||
| ||