Home › BODY › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM

BACK DOOR CLOSER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK POWER BACK DOOR ECU

B068464E08

  1. Disconnect the P13 and P14 ECU connectors, and check the voltage and resistance of each terminal of the wire harness side connectors.

    Terminal No.
    Wiring Color
    Condition
    Specified Condition
    P14-2 (B) - Body ground
    B-R - Body ground
    Constant
    10 to 14 V
    P13-10 (ECUB) - Body ground
    W-L - Body ground
    Constant
    10 to 14 V
    P13-9 (IG) - Body ground
    B-R - Body ground
    Ignition switch OFF → ON
    0 V → 10 to 14 V
    P14-8 (GND) - Body ground
    W-B - Body ground
    Constant
    Below 1 Ω
    P13-3 (HSW) - Body ground
    G-B - Body ground
    Back door opener switch OFF → ON
    10 kΩ or higher → Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  2. Reconnect the ECU connectors, and check the voltage of each terminal of the connectors.

    Terminal No.
    Wiring Color
    Condition
    Specified Condition
    P14-4 (CTYO) - Body ground
    G-W - Body ground
    Back door CLOSED → OPEN
    10 to 14 V → Below 1 V
    P13-7 (HAF) - Body ground
    R - Body ground
    Back door OPEN →
    Closer in operation →
    Back door CLOSED
    Below 1 V →
    10 to 14 V →
    Below 1 V →
    P13-21 (POS) - Body ground
    V - Body ground
    Back door OPEN →
    Closer in operation →
    CLOSED
    Below 1 V →
    10 to 14 V →
    Below 1 V →
    P13-8 (FUL) - Body ground
    B-W - Body ground
    Back door CLOSED → OPEN
    10 to 14 V → Below 1 V
    P13-12 (DC+) - Body ground
    L-W - Body ground
    Back door OPEN →
    Not completely closed →
    Motor in normal rotation (Right turn) →
    Motor in reverse rotation (Left turn) →
    Operation completed (Back door CLOSED)
    Below 1 V →
    Below 1 V →
    10 to 14 V →
    Below 1 V →
    Below 1 V
    P13-11 (DC-) - Body ground
    G - Body ground
    Back door OPEN →
    Not completely closed →
    Motor in normal rotation (Right turn) →
    Motor in reverse rotation (Left turn) →
    Operation completed (Back door CLOSED)
    Below 1 V →
    Below 1 V →
    Below 1 V →
    10 to 14 V →
    Below 1 V
    If the result is not as specified, the ECU may have a malfunction.