Home › BODY › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM

DTC    B2215    Back Door Closer Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a malfunction occurs in the position switch in the back door. This position switch detects if the back door is in the latch position and sends a position signal to the power back door ECU.

DTC No.
DTC Detection Condition
Trouble Area
B2215
Back door does not operate
  1. Back door lock assembly
  2. Power back door ECU
  3. Wire harness

WIRING DIAGRAM


B120069E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR ECU)


    B068432E02
  1. Disconnect the B10 lock and P13 ECU connectors.

  1. Check the resistance between the wire harness side connectors.

    Resistance (Check for open circuit):
    Terminal No.
    Specified Condition
    B10-6 - P13-21 (POS)
    Below 1 Ω

  1. Check the resistance between the B10 lock connector and body ground.

    Resistance (Check for open circuit):
    Terminal No.
    Specified Condition
    B10-4 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.INSPECT BACK DOOR LOCK ASSEMBLY


    B067754E02
  1. Check operation of the door lock.

    1. Using a screwdriver, push the latch in order to put the back door lock in the locked condition (full-latch position).

    2. Connect the battery positive (+) lead to terminal 1 and the battery negative (-) lead to terminal 2. Then, check operation of the latch.

      OK:
      The latch turns to the open-latch position

    3. Inspect motor operation when battery voltage is applied to the terminals.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      Clockwise (Motor in normal rotation)
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Counterclockwise (Motor in reverse rotation)



    B062719E02
  1. Check the back door courtesy switch resistance.

    1. Check the resistance between the terminals of the courtesy switch.

      Resistance:
      Door Lock Latch Position
      Terminal No.
      Specified Condition
      Open-latch position, Half-latch position
      3 - 4
      Below 1 Ω
      Full-latch position, Over-latch position
      10 kΩ or higher

  1. Check the back door latch switch resistance.

    1. Check the resistance between the terminals of the latch switch.

      Resistance:
      Door Lock Latch Position
      Terminal No.
      Specified Condition
      Open-latch position, Over-latch position
      4 - 5
      Below 1 Ω
      Half-latch position, Full-latch position
      10 kΩ or higher

  1. Check the position switch resistance.

    1. Connect the battery positive (+) lead to connector terminal 1 and the negative (-) lead to connector terminal 2.

      Resistance:
      Door Lock Latch Position
      Terminal No.
      Specified Condition
      Any position other than motor stop position (Motor in operation)
      4 - 6
      Below 1 Ω
      Motor stop position (Gear in original position)
      10 kΩ or higher



NG
REPLACE BACK DOOR LOCK ASSEMBLY
OK

REPLACE POWER BACK DOOR ECU