Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here


HINT:
The following items can be customized.

NOTICE:
  1. After confirming whether the items requested by the customer are applicable or not for customization, perform the customize operation.
  2. Be sure to record the current settings before customizing.
  3. When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization.


Power Back Door ECU 
DISPLAY (ITEM)
DEFAULT
CONTENTS
SETTING
PBD SW Operation
0.8s
Function that turns power back door switch ON when switch is pushed once or held down for 0.8 sec.
0.8s/ON
PBD Buzzer Volume
OFF
Function that adjusts volume of warning buzzer that notifies power slide door is operating
LARGE / SMALL / OFF
Wireless PBD Operation
0.8s
Function that operates power back door when transmitter switch is pressed in specified way (1-press, 2-presses, 0.8 sec.-press or OFF*1)
1 TIME/ 2TIMES / 0.8s PR / OFF
PBD Assist Close*2
ON
Function that helps power back door closing operation
ON / OFF
PBD Assist Open*3
OFF
Function that helps power back door opening operation
ON / OFF
*1 Wireless (transmitter switch) operation of the power slide door is disabled.
  1. *2 When this item is set to ON:
    1. When the back door is fully open, manually moving the back door approximately 12 cm within 0.5 sec. in the direction that the back door closes activates the power back door system to automatically close.
  1. *3 When this item is set to ON:
    1. When the back door is fully closed, pulling the outside activates the power back door system to automatically open after the back door is unlatched.