Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR DRIVE UNIT

POWER BACK DOOR DRIVE UNIT > INSPECTION

for Preparation Click here



1. INSPECT POWER BACK DOOR DRIVE UNIT


    B068913E02
  1. Remove the unit.

  1. Apply battery voltage to the terminals and check the motor operation.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 8
    Battery negative (-) → Terminal 7
    Open
    Battery positive (+) → Terminal 7
    Battery negative (-) → Terminal 8
    Closed

    If the result is not as specified, replace the drive unit.

  1. Check the resistance of the clutch terminals.

    Resistance:
    Terminal No.
    Specified Condition
    3 - 9
    4.0 Ω

    If the result is not as specified, replace the drive unit.

  1. Reinstall the unit with the connector connected.



    B068909E05
  1. Check the pulse of the pulse sensor.

    1. Using an oscilloscope, check the pulse generated when the door is manually opened and closed.

      Standard (Reference):
      Terminal
      Tool setting
      Vehicle condition
      1 - 2, 2 - 5
      10 V/DIV., 10 ms/DIV.
      Door moving

      If the result is not as specified, replace the drive unit.

      HINT:
      A cycle of the pulse changes between approx. 10 to 20 msec. according to the speeds that the slide door is moving.

  1. With the connector connected, check the voltage of the terminals of the power back door drive unit connector.