Home › BODY › ENGINE HOOD / DOOR › SLIDE DOOR LOCK RELEASE MOTOR

SLIDE DOOR LOCK RELEASE MOTOR > INSPECTION

for Preparation Click here



1. INSPECT SLIDE DOOR LOCK RELEASE MOTOR ASSEMBLY LH


    B068902E01
  1. Apply battery voltage and inspect operation of the motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Release operation
    No battery voltage is applied
    Original position

    If the result is not as specified, replace the motor assembly.



2. INSPECT SLIDE DOOR LOCK RELEASE MOTOR ASSEMBLY RH


    B068467E01
  1. Apply battery voltage and inspect operation of the motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Release operation
    No battery voltage is applied
    Original position

    If the result is not as specified, replace the motor assembly.



3. INSPECT SLIDE DOOR LOCK REMOTE CONTROL SUB-ASSEMBLY LH


    B068910E01
  1. Inspect the resistance of the switch. (Handle Operation Detect Switch Operation)

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    1 - 3
    Unlock
    10 kΩ or higher
    Lock
    Below 1 Ω

    If the result is not as specified, replace the control assembly.



    B068911E01
  1. Inspect the resistance of the switch. (Child Protection Detect Switch Operation)

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    4 - 5
    Unlock
    10 kΩ or higher
    Lock
    Below 1 Ω

    If the result is not as specified, replace the control sub-assembly.



4. INSPECT SLIDE DOOR LOCK REMOTE CONTROL SUB-ASSEMBLY RH


    B069777E01
  1. Inspect the resistance of the switch. (Handle Operation Detect Switch Operation)

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    1 - 3
    Unlock
    10 kΩ or higher
    Lock
    Below 1 Ω

    If the result is not as specified, replace the control sub-assembly.



    B069778E01
  1. Inspect the resistance of the switch. (Child Protection Detect Switch Operation)

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    4 - 5
    Unlock
    10 kΩ or higher
    Lock
    Below 1 Ω

    If the result is not as specified, replace the control sub-assembly.