HOOD > ADJUSTMENT |
| 1. INSPECT HOOD SUB-ASSEMBLY |
Check that the clearance is within the standard range.

| A | B | C | D | E |
| 8.0 +- 1.5 mm (0.315 +- 0.059 in.) | 4.0 +- 1.5 mm (0.157 +- 0.059 in.) | 0.4 +- 1.5 mm (0.015 +- 0.059 in.) | 5.0 +- 1.5 mm (0.197 +- 0.059 in.) | 1.1 +- 1.5 mm (0.043 +- 0.059 in.) |
| 2. ADJUST HOOD SUB-ASSEMBLY |
![]() |
Horizontally adjust the hood.
Loosen the 4 hood hinge mounting bolts on the hood side.
![]() |
Adjust the clearance by moving the hood, so that it will be in the standard range.
Tighten the hood side hinge bolts after the adjustment.
![]() |
Adjust the height of the hood front end using the cushion rubber.
Adjust the cushion rubber so that the hood and the fender will be aligned.
Adjust the hood lock.
Remove the front bumper cover .
![]() |
Using a screwdriver, disengage the 4 claws and remove the hood lock release lever protector.
![]() |
Loosen the 3 hood lock mounting bolts.
Adjust the striker position by moving the hood lock, so that the striker can enter smoothly.
Tighten the hood lock bolts after the adjustment.