Home › BODY › ENGINE HOOD / DOOR › FRONT DOOR

FRONT DOOR > ADJUSTMENT

for Preparation Click here


HINT:
  1. On the RH side, use the same procedures as on the LH side.
  2. Since a centering bolt is used as a door hinge mounting bolt on the body side and the door side, the door can not be adjusted with it on. Substitute a bolt with a washer for the centering bolt.



1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH


  1. Check that the clearance is within the standard range.


    B067481E01


    Standard:

    A
    B
    C
    D
    E
    F
    5.0 +- 1.5 mm (0.197 +- 0.059 in.)
    5.5 +- 1.5 mm (0.220 +- 0.059 in.)
    5.2 +- 1.5 mm (0.205 +- 0.059 in.)
    160 mm (6.30 in.)
    9.2 +- 1.5 mm (0.362 +- 0.059 in.)
    6.3 +- 1.5 mm (0.250 +- 0.059 in.)



2. ADJUST FRONT DOOR PANEL SUB-ASSEMBLY LH


    B067487
  1. Using SST, horizontally and vertically adjust the door by loosening the body side hinge bolts.

    SST
    09812-00010  
    09812-00020  

  1. Tighten the door side hinge bolts after the adjustment.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }



    B067482
  1. Adjust the door forward / rearward and vertically by loosening the door side hinge bolts.

  1. Tighten the door side hinge bolts after the adjustment.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }



    B068038
  1. Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

  1. Tighten the striker mounting screws after the adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }