FRONT DOOR > REASSEMBLY |
| 1. INSTALL FRONT DOOR WIRE LH |
![]() |
Install the wire with the 2 bolts.
Connect the wire clips.
| 2. INSTALL FRONT DOOR CHECK ASSEMBLY LH |
![]() |
Apply MP grease to the sliding area of the door check.
Install the door check to the door panel with the 2 nuts.
Apply adhesive to the threads of the bolt.
Install the door check to the body with the bolt.
| 3. INSTALL FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH |
![]() |
Install the open rod to the outside handle frame.
Slide the outside handle frame in the indicated by the arrow mark in the illustration.
Using a torx socket wrench (T30), install the outside handle frame with the screw.
Install the outside handle pads front and rear.
| 4. INSTALL FRONT DOOR HANDLE ASSEMBLY OUTSIDE LH |
![]() |
Install the outside handle by pushing in the direction indicated by the arrow mark in the illustration.
| 5. INSTALL FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH |
Apply MP grease to the sliding and area of the door lock.
Install a new door lock wire harness packing to the door lock.
![]() |
Insert the open rod into the lock and then set it to the door panel.
![]() |
Apply adhesive to the threads of the screws.
Using a torx socket wrench (T30), install the lock with the 3 screws.
Connect the lock connector.
| 6. INSTALL FRONT DOOR OUTSIDE HANDLE COVER |
![]() |
Using a torx socket wrench (T30), install the outside handle cover with the screw.
Install the hole plug.
| 7. INSTALL FRONT DOOR FRAME SUB-ASSEMBLY REAR LOWER LH |
![]() |
Install the frame with the bolt.
| 8. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
Using a torx driver (T25), install the regulator motor with the 3 screws.
| 9. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH |
![]() |
Apply MP grease to the sliding and rotating parts of the window regulator.
![]() |
Install the window regulator with 6 bolts.
Connect the window regulator connector.
| 10. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH |
![]() |
Install the glass run.
Insert the door glass into the door panel along the glass run in the direction indicated by the arrow mark in the illustration.
![]() |
Install the door glass to the window regulator with the 2 bolts.
Reset the power window motor (Click here).
Inspect operation of the power window.
Connect the power window switch to the wire harness and turn the ignition switch ON.
Repeat UP and DOWN operation several times in manual operation.
| 11. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH |
![]() |
Install the mirror with the 3 nuts.
Connect the mirror connector.
| 12. INSTALL FRONT DOOR SERVICE HOLE COVER LH |
![]() |
Apply butyl tape to the door panel, as shown in the illustration.
Install the service hole cover.