Home › BODY › ENGINE HOOD / DOOR › SLIDE DOOR (w/o Power Slide Door)

SLIDE DOOR (w/o Power Slide Door) > REMOVAL

for Preparation Click here


HINT:
On the RH side, use the same procedures as on the LH side.



1. REMOVE SLIDE DOOR
  1. Remove the rear door scuff plate .

  1. Remove the back door scuff plate .

  1. Remove the quarter trim panel .

  1. Remove the upper rail cushion from the rail upper.



    B068386
  1. Disconnect the 2 connectors from the body side and remove the bolt and wire.



    B068589E01
  1. Open the quarter glass.

  1. Using a screwdriver, disengage the clip and 2 claws, remove the rail end moulding.

    HINT:
    Tape the screwdriver tip before use.



    B069321E01
  1. Remove the 2 bolts and bracket center No. 2.



    B067901
  1. Remove the 2 nuts and open stop.



    B060924E01
  1. Rotate the base of the slide door roller lower in the direction indicated by arrow in the illustration and then remove the roller from the cut area of the lower rail from the body side.



    B069213E01
  1. Move the slide door rearward and then remove the slide door roller upper from the cut area in the rear part of the slide door rail upper.



    B069212E01
  1. Move the slide door further rearward and then remove the slide door hinge center from the rear part of the slide door rail center. Then, remove the slide door.



2. REMOVE SLIDE DOOR RAILS
  1. Remove the roof headlining (Click here).

  1. Remove the 2 bolts, 2 nuts and the rail upper.

  1. Remove the 2 screws and the rear side rail.

  1. Remove the 3 screws and the rail center.



3. REMOVE SLIDE DOOR FULL OPEN STOP LOCK ASSEMBLY LH


    B067501E01
  1. Disconnect the 2 cables.

  1. Remove the 2 bolts and lock.



4. REMOVE SLIDE DOOR ROLLER ASSEMBLY LOWER LH


    B067499
  1. Remove the 3 bolts and roller.



5. REMOVE SLIDE DOOR HINGE ASSEMBLY CENTER LH


    B067496E01
  1. Remove the 3 bolts and hinge.

  1. LH side:
    Remove the cover.



6. REMOVE SLIDE DOOR ROLLER ASSEMBLY UPPER


    B067498
  1. Remove the 2 bolts and roller.



7. REPLACE SLIDE DOOR HALF OPEN STOPPER SUB-ASSEMBLY


    B067517
  1. Using a screwdriver, remove the 2 clips and cover.

    HINT:
    Tape the screwdriver tip before use.



    B069065E01
  1. Remove the 2 bolts and disconnect the control cable from the open striker.



    B067518
  1. Disconnect the control cable from the half open stopper.

  1. Remove the 2 bolts and half open stopper.



8. REPLACE SLIDE DOOR HALF OPEN STOPPER CONTROL ASSEMBLY


    B067520E01
  1. Remove the 2 nuts and half open stopper control.

  1. Remove the control cable.



9. REPLACE SLIDE DOOR OPEN STRIKER LH


    B067519E01
  1. Remove the 2 nuts and open striker.



10. REPLACE SLIDE DOOR OPEN STRIKER RH

HINT:
Use the same procedures for the LH side.



11. REPLACE SLIDE DOOR OPEN STOP LH


    B067901
  1. Remove the 2 nuts and open stop.



12. REPLACE SLIDE DOOR OPEN STOP RH

HINT:
Use the same procedures for the LH side.