Home › BODY › ENGINE HOOD / DOOR › BACK DOOR

BACK DOOR > ADJUSTMENT

for Preparation Click here


HINT:
  1. On the RH side, use the same procedures as on the LH side.
  2. Since a centering bolt is used as door hinge mounting bolts on the body side and the door side, the door cannot be adjusted with them on. Substitute a bolt with a washer for the centering bolt.



1. INSPECT BACK DOOR PANEL SUB-ASSEMBLY


  1. Check that the clearance is within the standard range.


    B067794E01


    Standard:

    A
    B
    C
    D
    106. +- 1.5 mm (0.417 +- 0.059 in.)
    7.0 +- 1.5 mm (0.276 +- 0.059 in.)
    6.0 +- 1.5 mm (0.236 +- 0.059 in.)
    5.7 +- 1.5 mm (0.224 +- 0.059 in.)



2. ADJUST BACK DOOR PANEL SUB-ASSEMBLY


    B067789E01
  1. Adjust the door forward / rearward and vertically by loosening the body side hinge nuts and bolt.

  1. Tighten the body side hinge nuts and bolt after the adjustment.

    Torque:
    19.5 N*m{ 200 kgf*cm , 14 ft.*lbf }



    B067788E01
  1. Horizontally and vertically adjust the door by loosening the door side hinge bolts.

  1. Tighten the body side hinge bolts after the adjustment.

    Torque:
    19.5 N*m{ 200 kgf*cm , 14 ft.*lbf }

  1. Using a screwdriver, remove the back door scuff plate.

    HINT:
    Tape the screwdriver tip before use.



    B067790
  1. Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.

  1. Tighten the striker mounting screws after the adjustment.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }