Home › BODY › ENGINE HOOD / DOOR › BACK DOOR

BACK DOOR > DISASSEMBLY

for Preparation Click here



1. REMOVE BACK DOOR GARNISH CENTER


    B069688E01
  1. Using a clip remover, disengage the 5 clips and remove the garnish center.



2. REMOVE BACK DOOR SIDE GARNISH LH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



3. REMOVE BACK DOOR SIDE GARNISH RH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



4. REMOVE BACK DOOR PULL STRAP


    B067784E01
  1. Using a screwdriver, disengage the claws and remove the strap cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and strap.



5. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B067783E01
  1. Using the screwdriver, disengage the 14 clips and remove the trim board.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the service hole cover from the trim board.



6. REMOVE BACK-UP LIGHT ASSEMBLY LH


    I035545E03
  1. Disconnect the connector.

  1. Release the 2 claw fittings and remove the 4 nuts and the back-up light assembly.



7. REMOVE BACK-UP LIGHT ASSEMBLY RH


    I035545E03
  1. Disconnect the connector.

  1. Release the 2 claw fittings and remove the 4 nuts and the back-up light assembly.



8. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
  1. Disconnect the licence light connector.



  1. Remove the 5 nuts, clip and back door outside garnish sub-assembly.


    B067628



    B067629
  1. Remove the 2 screws and back door outside opener switch.



9. REMOVE BACK DOOR LOCK ASSEMBLY


    B067787
  1. Disconnect the connector.

  1. Remove the 3 bolts and lock.



10. REMOVE BACK DOOR BASE STOPPER BRACKET
  1. Remove the 4 bolts and 2 stopper brackets.



11. REMOVE BACK DOOR STOPPER LOWER
  1. Remove the 4 bolts and 2 stoppers.



12. REMOVE REAR SPOILER COVER
  1. Disconnect the center stop light connector.



    B067744
  1. Remove the 3 nuts.

  1. Using a clip remover, disengage the 2 clips to remove the rear spoiler.



13. REMOVE BACK DOOR STAY SUB-ASSEMBLY LH


    H019020
  1. Remove the 2 bolts and disconnect the stay from the body panel.

  1. Using the screwdriver, disengage the clips and remove the stay from the door panel.

  1. Remove the bolt from door panel.



14. REMOVE BACK DOOR STAY SUB-ASSEMBLY RH


    H019020
  1. Remove the 2 bolts and disconnect the stay from the body panel.

  1. Using the screwdriver, disengage the clips and remove the stay from the door panel.

  1. Remove the bolt from door panel.