Home › BODY › ENGINE HOOD / DOOR › BACK DOOR SUPPORT

BACK DOOR SUPPORT > DISPOSAL

for Preparation Click here


HINT:
On the RH side, use the same procedures as on the LH side.



1. DISPOSE OF BACK DOOR STAY SUB-ASSEMBLY LH


    B065104E10
  1. Horizontally fix the stay in a vise with the piston-rod pulled out.

  1. Wearing safety glasses, gradually cut a part between A and B as shown in the illustration using a metal saw to gradually release the gas.

    Dimensions:
    a
    b
    80 mm (3.15 in.)
    20 mm (0.80 in.)

    NOTICE:
    Although the gas inside the damper stay is colorless, odorless and harmless, there is a possibility that metal debris from cutting could enter the assembly. Therefore, cover it with cloth or something similar.