Home › BODY › WINDSHIELD / WINDOWGLASS › BACK DOOR GLASS

BACK DOOR GLASS > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR GARNISH CENTER


2. REMOVE BACK DOOR SIDE GARNISH LH


3. REMOVE BACK DOOR SIDE GARNISH RH


4. REMOVE BACK DOOR STRAP COVER


5. REMOVE BACK DOOR PULL STRAP


6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


7. REMOVE BACK DOOR SERVICE HOLE PLATE


8. REMOVE REAR SPOILER COVER (W/ REAR SPOILER)


9. REMOVE FRONT WIPER ARM HEAD CAP


10. REMOVE REAR WIPER ARM


11. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY


12. REMOVE BACK DOOR GLASS


    B067573E01
  1. Pass a piano wire between the body and glass from the interior.



    B065166E01
  1. Tie both wire ends to wooden blocks or similar objects.

    HINT:
    Apply protective tape to the outer surface to prevent the surface from being scratched.

    NOTICE:
    When separating the glass, take care not to damage the paint and interior and exterior ornaments.

  1. Cut off the adhesive by pulling piano wire around it.

  1. Using a suction rubber, remove the glass.

    NOTICE:
    Leave as much adhesive on the body as possible when removing the glass.



13. CLEAN BACK DOOR GLASS


    BO04421
  1. Clean the outer circumference of the glass white gasoline.

    NOTICE:
    1. Do not touch the glass surface after cleaning it.
    2. Be careful not to damage the body.