Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Back-up Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the back-up power source for the A/C amplifier. Power is supplied even when the ignition switch is off and is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM


E146556E03


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    ECU-B Fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE (ECU-B)
OK


2.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY)


    E143742E49
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A9-20 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE