Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > ACC Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit supplies power to the A/C amplifier and the illumination for the clock.

WIRING DIAGRAM


E146556E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU ACC)
  1. Remove the ECU ACC fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    ECU ACC Fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE (ECU ACC)
OK


2.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY)


    E143742E48
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A9-19 (ACC) - Body ground
    Ignition switch: OFF
    Below 1 V
    A9-19 (ACC) - Body ground
    Ignition switch: ACC
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE