Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR INLET CONTROL SERVO MOTOR (for Automatic Air Conditioning System)

AIR INLET CONTROL SERVO MOTOR (for Automatic Air Conditioning System) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AIR INLET CONTROL SERVO MOTOR


    E145188E03
  1. Remove the air inlet control servo motor.

  1. Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the lever turns to "RECIRCULATION" side smoothly.

  1. Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 4, then check that the lever turns to "FRESH" side smoothly.

    NOTICE:
    While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

    If the operation is not as specified, replace the air inlet control servo motor.