Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR MIX CONTROL SERVO MOTOR (for Front Passenger Side)

AIR MIX CONTROL SERVO MOTOR (for Front Passenger Side) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AIR MIX CONTROL SERVO MOTOR


    E109236E09
  1. Remove the air mix control servo motor.

  1. Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the lever turns to "COOL" side smoothly.

  1. Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 4, then check that the lever turns to "HOT" side smoothly.

    NOTICE:
    While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

    If the operation is not as specified, replace the air mix control servo motor.