COMPRESSOR AND MAGNETIC CLUTCH > INSPECTION |
| 1. INSPECT MAGNETIC CLUTCH CLEARANCE |
![]() |
Set the dial indicator to the magnetic clutch hub.
Connect the battery positive lead to the terminal 1 of the magnet clutch connector and the negative lead to the earth wire. Turn on and off the magnetic clutch and measure the clearance.
| 2. INSPECT COMPRESSOR OIL |
When replacing the compressor and magnetic clutch with a new one, after gradually removing the refrigerant gas from the service valve, drain the following amount of oil from the new compressor and magnetic clutch before installation.
| 3. INSPECT COMPRESSOR AND MAGNETIC CLUTCH |
![]() |
Disconnect the connector from the compressor and magnetic clutch.
![]() |
Disconnect the connector from the magnetic clutch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (MG+) - 1 | Always | Below 1 Ω |
| 3 (MG+) - Body ground | Always | 10 kΩ or higher |
| 4. INSPECT MAGNETIC CLUTCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - Body ground | Always | 3.4 to 3.8 Ω |
When connector terminal A1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.
If the result is not as specified, replace the magnetic clutch.