COMPRESSOR AND MAGNETIC CLUTCH > REASSEMBLY |
| 1. INSTALL MAGNETIC CLUTCH ASSEMBLY |
![]() |
Install the magnetic clutch stator while aligning the protrusion on the stator with the notch on the air compressor assembly as shown in the illustration.
![]() |
Using a snap ring expander, install a new snap ring with the chamfered side facing up.
Install the screw and connect the connector.
![]() |
Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing up.
Install the magnet clutch washer and the magnet clutch hub.
![]() |
Using vise pliers, hold the magnetic clutch hub and install the bolt.